#Factorio water pump full

This can be used to control some parts of a player's factory. If the pump is powered but has a circuit condition, it will only let fluids through when the condition is met.If unpowered, the pump doesn't let anything through.When powered, the pump will let fluids through, but only in its set direction.It will not connect if a circuit condition is preventing it, or it is unpowered. When a fluid wagon is stopped adjacent, the pump head will connect to the top of the nearest tank and begin transferring fluids. When a pump is placed with one end facing a rail track and the other end connected to a pipe, it will visually change. You might need to wait several minutes for water level in the pipes to stabilize. Then add pipes until you see the performance of one steam engine drop.

Pumps can load and unload fluid wagons at train stops. The easiest method is to take some steam engines (6 water/sec each) and hook them up to an independent radar network so they run at 100 capacity. More information on pump and pipe throughput can be found on the forums. This is further limited by the input fluid container: the pump can never move more fluid than is available and it is therefore generally beneficial to have a pressurized storage tank directly at its input.

#Factorio water pump full

10 steam engines will consume the full out put of an off shore pump at full output and thats why you can find pipes with varying amounts of water in the pipe. steam engines consume water even if its unheated it will consume more when running at full power. Pumps can move 200 units of fluid per tick, or 12000 per second. the offshore pump only produces so much water at a time. One steam engine consumes 30 steam per second, and one offshore pump produces 1200 water per second. Parallel pumps preventing side connections. Factorio Boiler to Steam Ratio Optimal Ratio.